They are not far away from our shop at Coolings Knockholt, near Sevenoaks , this is an added bonus for our customers as they are buying from a local UK based company. Where to Buy?
Postcode Required. Or find a worldwide stockist. Let us calculate your dosage for you! I know my system's measurements and want to: Calculate my volume. Calculate volume.
As mentioned before, only if a severely high spike of ammonia occurs in the fish tank, should zeolite be used for a limited period of time. Adding zeolite to your aquarium can result in the disruption or the prevention of the nitrification process.
The nitrogen cycle or the nitrification process is the creation of good and beneficial bacteria within a fish tank and an aquarium filter. It is highly recommended to get rid of zeolite once the levels of ammonia drop within an aquarium. Apart from this, it is recommended to replace it with a media, such as activated carbon, to flush out any other substances from the water. Carbon helps get rid of a variety of things from an aquarium.
Some of those elements include odor, colors, medicines, and even organic matter. However, carbon also gets exhausted after a few weeks. Both zeolite and carbon have to be replaced in the aquarium within a few weeks if you want to keep using them.
You can either replace them collectively or separately. The zeolite that is specifically meant for freshwater should never be utilized in saltwater or any brackish fish tanks.
The impact of this on the chemistry of water can prove to be very lethal for corals present in saltwater aquariums. Also, refrain from adding any type of salt in a freshwater aquarium while zeolite is being used in the tank. Adding salt basically reverses the entire purpose of using zeolite. It causes the zeolite to release all the ammonia that it had previously absorbed. This results in a sudden and very dangerous ammonia spike.
Zeolite is similar to activated carbon. Zeolite, like carbon, is placed in a bag within the filter. This mineral can either be bought in loose bulk or found in measured media bags. If you have a canister filter, the zeolite must be put between the foam or mechanical media or the rings and biological media. A few zeolite chips are placed inside a media bag that can be removed or even scattered inside the fish tank later on.
This offers a large surface area to nitrifying bacteria. A few manufacturers also offer a zeolite pad, which can be cut to fit within a power filter. It can also be placed right next to the foam within a canister filter. Rinse the zeolite thoroughly with fresh water. Tap water will work just fine, but distilled or reverse osmosis water can be used for a final rinse if you have concerns about contaminants.
Remove the zeolite from its mesh bag or other container and spread the zeolite in a single layer on a baking sheet. Remove the baking sheet from the oven and allow the zeolite to cool before placing it back in its filtration container.
Place the zeolite on a baking sheet or other flat, portable surface and spread it out in a single layer if possible. If it is enclosed in a sealed mesh, simply place the bag on the surface. Put the zeolite in a location where it will receive direct sunlight for the greater part of the day.
The sun and air method works best during the summer months. You can increase the amount of heat the zeolite is subjected to by covering it with black plastic and weighing the plastic down. If you use this method, be sure to expose the zeolite to fresh air before using in order to make sure that any gases trapped by the plastic covering have been thoroughly vented.
The Sun and Air method is also good if the zeolite is contained in a plastic mesh that will not tolerate an oven temperature of degrees F.
Water softener salt can be pulverized and used. If you have a lot of zeolite to recharge, this might be more economical.
0コメント