Where to get streaks in hair




















Bleaching and dying hair can really dry it out, so you'll want to give your hair a good head start. In the days leading up to streaking it, don't shampoo it or use hairspray and other hair products.

Let your hair's natural oils protect it from the chemicals you'll be applying. When you're ready to streak it, start with hair that is completely dry. Check the instructions before use. Pull out the sections of hair you're streaking. You need to separate the hair that will be bleached and colored from the rest before you can begin the process. You can do this with a highlighting cap, or by using hair clips and aluminum foil. You place the cap on your head and use a hook to pull strands of hair through tiny holes.

Use this if you want all-over streaks. Hair clips and aluminum foil is the better technique to use if you want just a few large, bold streaks. Pull back the hair you don't intend to streak and clip it away from your head. Now take a long strip of aluminum foil and place it underneath the section of hair you want to streak. Pinch it around the roots to keep it in place.

Mix the products. Put the bleach, developer, and red gold corrector in a bowl. Read the instructions that came with the bleach powder and developer to figure out how much to mix together. The finished mixture will look bluish white. Apply the bleach. Use the tint brush to apply bleach from the tips to the roots of the sections of hair. Use only enough bleach needed to cover and saturate the hair.

Continue applying bleach until the hair is completely covered. The chemicals used in bleach are strong and can stain your hands and burn your skin. Do not get bleach anywhere near your eyes. If you're using the highlighting cap method, cover your head with a large piece of plastic wrap while the bleach sets in. If you're using the aluminum foil method, fold the foil over the section of hair to cover it and protect it from drying out. Check your hair after fifteen minutes.

Use a towel to wipe off a little bleach. If your hair is blonde, the bleaching process is finished. If it still looks dark, apply more bleach to the area you wiped off, replace the plastic wrap or aluminum foil, and give it more time.

Keep checking every 10 to 15 minutes until it is finished. Don't leave the bleach in for more than 45 minutes, even if your hair still looks dark. Your hair can get damaged if you leave the bleach in longer. You may have to wait a day and bleach it again to achieve the desired effect this is common for people with very dark brown or black hair.

Wash out the bleach. Carefully rinse the bleach from the strands of hair that you treated. Keep the rest of your hair separate so that it doesn't get bleach on it. Rinse until the water runs clear. Use a purple shampoo. A purple shampoo will effectively tone your hair and take the yellow out of it. Wash your hair with purple shampoo as soon as you are done rinsing the bleach from your hair. Allow it to sit on your hair for about five minutes.

Then, rinse it out thoroughly, and pat your hair dry with a towel. Method 3. Prepare your hair and hair dye. Re-section your hair according to the strands that have been bleached. Sometimes you will mix the dye with a developer in a bowl. Or, you will squeeze the hair dye directly into a bowl. Use a brush to apply the hair dye.

Completely cover the strands of bleached hair with the dye from root to tip. Repeat this process until all of the bleached strands have been covered in color. If you're using the aluminum foil method for separating large pieces of hair, replace the aluminum foil you used to bleach your hair with a fresh piece for dying it. Follow any specific application directions that came on the dye.

Let the color set. In most cases, you'll need to let the dye work for about 30 minutes to make sure the color sets. Look your hair after ten or fifteen minutes to check the progress, though. Rinse out the dye. If not, you can begin rinsing your hair out. Submerge your hair fully under water until all of the dye has been washed out. You can stop rinsing when the water runs clear. Condition your hair. The dyeing process can leave your hair dry, so make sure to condition your hair when you have rinsed the dye out of it.

Any type of color-safe conditioner will work, but it is best to use a deep conditioner made for color-treated hair. Allow the deep conditioner to sit for five to ten minutes. Use the deep conditioner once a week to keep your hair soft.

Maintain your streaks. Thanks to an innovative highlighter applicator, you can choose either broad highlights or feathery slim ones — all to create your individual look!

The Schwarzkopf Super Strands range ensures long lasting vibrant color — give it a go for a summery feel! Step by step to perfect highlights Prepare your equipment. Once you have ensured you have all these things, move on to step 2. A good rule of thumb is to first read the instructions through once before you start!

That way you have an idea of what you need to do and when. Put on your gloves. Mix it up! Mix the lightening powder and developer together so they form a paste. Divide the strands you want to highlight and get creative!

Using the highlighter brush, apply the mixture from the roots downwards in a fluid motion, going over bits you miss. Your salon Find your salon Find the closest salon Geolocate. Book now Our Brand. Find your salon. Our DNA. Our Experts. Our News. Join the Team. Our brand. Deeply hydrate your locks with the lightweight Oil Therapy collection. Spring - Summer Collection. Autumn - Winter Collection. Speed Up-Do, style me a bun! Style Bar. Care Ritual. Exclusive Services.

Urban Care. Urban Style. Must-have hairstyles. Cuts by hair length. Our Hairstyle tutorials. All the hairstyle folders. Advice by colour type. Temporary hair colour. All Hair colouring folders. Hair colouring. Hair care advice by hair type. Sun care. All hair care folders. Hair care. Keratin Therapy, a Jean Louis David innovation. Street Style.



0コメント

  • 1000 / 1000